上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
42 / 53
3.3.1 Select a WCS
This operation is used to select a WCS from G54 to G59 for machining.
Before selecting a WCS, press → 1 → F2, and modify the value of parameter
N62023 Ignore Coordinate System Instruction to Yes.
To select a WCS, do the following:
1. To move the curser to the target coordinate column, press ← or →.
The color of the column turns into light blue.
2. To select the coordinate system, press F1.
The name of the selected WCS GXX is highlighted in Part Offset area, and shows in
the coordinate display areas on the Coor interface under Gen. functional area and
Coor Manager interface under Adv. interface.
3.3.2 Set the Offsets
This operation is used to set the workpiece offset and the public offset. The former is
used to show the distance of the workpiece origin relative to the machine origin,
while the latter is used to adjust the workpiece origin of each axis for all WCSs.
To set the offsets, do the following:
1. Set the workpiece offset:
1. To enable Modify, press T, and input the manufacturer password.
2. Press ↑, ↓, ← or → to select the target input box, press Enter, and input
the modified value.
2. Set the public offset:
1. To enable Modify, press H, and input the manufacturer password.
2. Press ↑, ↓, ← or → to select the target input box, press Enter, and input
the modified value.
3. Optional: To deepen (reduce) or lift (increase) Z-axis public offset,
press F7 or F8, and input the adjusted value.
The adjusted value is an accumulated value and it does not differentiate
positive value and negative value.
After setting, press T and H to disable modifying the workpiece offset and public
offset.
To Next Page
Loading...
