WEIHONG NK300CX - Page 48

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
48 / 53
2. Press F3. Line Selection dialog box pops up:
– Current line: show the line number of the current command.
– Total line: show the total line of the loaded program line.
3. To specify the start line for machining, do one of the following:
– Input a line number in the Start Line input box.
Valid range: [Current line, End line]
– Specify the tool number in Goto Line with Tx input box, press F2 and
start searching. The system automatically locates to the line where the
tool number appears, and uses it as the start line.
Pressing F2 several times can locates to the different lines where the
tool number appears.
It is only effective to G code files.
4. To specify the end line for machining, input a line number in the End Line input
box.
Valid range: [Start line, Total line]。