上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
12 / 53
4. Keys for mode selection
Used to select a machining mode among REF.Point, JOG, Auto, Handle and
Step.
JOG, Handle, Step are referred as Manual mode.
5. Extension keys
Used to customize extension functions, including K1, K2, K3 and K4 keys.
In Shoe Machine Control System, K1 key is used as an air brake key for frock
clamp. Before each machining, the system will judge whether the fixture is
clamped. Only when it is clamped, the system will start machining. Otherwise, a
yellow alarm occurs.
6. Keys for spindle control
Used to control the spindle movement, including CW, Stop and CCW keys.
7. E-stop switch
Used to stop the movement of the machine tool when the machine tool is in
danger, so as to protect the operator and machine tool.
After danger is cleared, you can rotate the switch clockwise to remove the E-
stop alarm.
8. Keys for axis direction
Used to manually move each axis.
In Manual mode:
– Press an axis direction key and Rapid key at the same time. The axis
moves at rapid jog speed.
– Press an axis direction key. The axis moves at jog speed.
9. Power Switch
Used to control power on or off.
10. Keys for movement control
Used to control the movement of the machine tool, including START, STOP,
Pause, and Resume keys.
See Execute Machining for details.
To Next Page
Loading...
