上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
46 / 53
3. To enable tool selection, modify the value of one of the following parameters to
Yes according to the type of loaded program file:
– Parameter N62022 Enable Tool Selection for G Code File
– Parameter N65203 Enable Tool Selection for ENG File
To select tools for machining, do the following:
1. Load a G code or an ENG program file containing several tools:
– After loading an ENG file with 5.50 to 5.53 version, Modify Tool No. in
ENG File dialog box pops up:
Proceed to Step 2.
– After loading a G code file or an ENG with other versions, Select Tool for
ENG/G File dialog box pops up:
Proceed to Step 3.
To Next Page
Loading...
