Instructions for Assembly
Item number 116519-0000 Subject to technical modifications
Version 4 23.04.2014 Page 38/47
Cassita II/Cassita II LED
The end positions for the drive are pre-set at the factory. Should these need to be
adjusted, however, always follow the instructions provided in the technical documents
that accompany the electric drive. When adjusting the motor, make sure that the fabric is
always wound up around the roller tube.
Check that the drive is switched off
1. Once the awning has been installed, check that the drive has been switched off
correctly. The cassette must close when the awning is retracted.
2. Re-set if necessary.
If a larger angle of inclination is set, it may be necessary to re-set the end positions for
the motor.
To Next Page
Loading...
