Welbilt CREM ONE - Enabling; Disabling Water Tank Alarms

ONE
22
SERVICE PROGRAMMING_2B
· Enabling / disabling water tank alarms
To enable or disable the water tank alarms, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When Water tank alarm icon (X) is shown on the display, select with K3 and K4 buttons to scroll
between enabled or disabled. Accept with K2.
3. Press K1 (home icon) to come back to Stand-by mode (OFF)
Important:
This setting must remain always on and could be disabled for the following working
conditions only:
Machines plumbed to the water mains and with the water inlet selector tap working on
‘TAP’ position.
Water supply selector
TANK
TAP
Note:
If Water tank alarms are disabled, water tank lling time-out and water tank lling delay
parameters will be disabled as well.
i