Welch Allyn 5300P Directions For Use

Directions for Use Chapter 2 Setup 27
Changing Temperature Type and Measurement Units
Default setting: F (Fahrenheit predictive).
To change the temperature type and the temperature measurement units:
1. With the monitor on, press repeatedly until TEMP MODE appears in the display
window. One or two green LEDs to the right of the temperature window illuminate to
indicate the selected temperature type.
2. Press or as needed to cycle to the desired display:
F (Fahrenheit Predictive)
FM (Fahrenheit Monitored)
C (Celsius Predictive)
CM (Celsius Monitored)
3. To select the displayed units and return to normal operation, either do nothing for 10
seconds or press any button other than or . If you press a function button (such
as ), the monitor returns to normal operation with that function ( ) activated.
For information on temperature measurements, see “Patient Monitoring” on page 31.
SYS
DIA
SpO2 %
/min
mmHg
ºC
ºC
M
TEMP MODE
SYS
DIA
SpO2 %
/min
mmHg
ºF
ºF
0
98
.6
20:30:16
79
119

Welch Allyn 5300P Specifications

General

Brand	Welch Allyn
Model	5300P
Category	Medical Equipment
Language	English