Directions for Use Chapter 5 Reviewing Patient Data 63
• is pressed again; the monitor prints an error log (if any errors occurred) and a
footer, and then printing stops.
• A nonrecoverable error condition is detected; printing stops immediately.
• A battery failure condition is detected. Printing is suspended as long as the
battery failure continues; if the AC power adapter is connected before the monitor
shuts down, printing resumes.
Printer Output
The printer standard report consists of a header, patient information, patient data (table
heading, date, time, range and alarm flags, and measurement readings), an error legend
and a footer. If the monitor receives a print request and no data is available, it prints only
the header and footer.
Header
Patient Information
Patient Data
The contents of the Patient Data block reflect the configuration of the monitor; that is,
with or without the SpO
2
option and with or without the temperature option.
For a single cycle, all data except temperature is printed on one line; the temperature
data, if it exists, is printed on a second line. If the data for a single parameter is not
available, nothing is printed in the space provided for that parameter.
The patient data is displayed in a table consisting of a table heading, the current date, and
rows of patient vital-sign data.
| (R) |
| Vital Signs Monitor |
||
Welch Allyn
| Patient Name:___________________ |
| Patient ID:_____________________ |
| Physician:______________________ |
| Procedure:______________________ |
| Comments:_______________________ |
| ________________________________ |
| ________________________________ |
||
To Next Page
Loading...
Need help?
General
