Wenglor P1PY201 - Personnel Qualifications; Modification of Products; General Safety Precautions; Laser Warnings

2 ‒ For Your Safety | P1PY201 ‒ Laser Distance Sensor ToF 8
2.3 Personnel Qualifications
• Suitable technical training is a prerequisite.
• In-house electronics training is required.
• Trained personnel who use the product must have (permanent) access to the operating instructions.
DANGER
Risk of personal injury or property damage in case of incorrect initial start-up and
maintenance!
Personal injury and damage to equipment may occur.
à Adequate training and qualification of personnel
2.4 Modification of Products
DANGER
Risk of personal injury or property damage if the product is modified!
Personal injury and damage to equipment may occur. Noncompliance may result in loss of the CE and/or
UKCA mark and voiding of the warranty.
à Modification of the product is not permitted
2.5 General Safety Precautions
INFORMATION
These instructions are an integral part of the product and must be kept on hand for the entire duration of
its service life.
In the event of possible changes, the current version of the operating instructions can be found at
www.wenglor.com in the product’s separate download area.
Read the operating instructions carefully before using the product.
Protect the sensor against contamination and mechanical influences.
2.6 Laser Warnings
EN 60825-1:2014
LASER CLA SS 1
Laser Class 1 (EN60825-1)
Applicable standards and safety regulations must
be observed.