To Next PageTo Next PageWhat to do if the hydraulic pressure switch block is active in my Westen Boiler?
If the hydraulic pressure switch block is active, it might be due to incorrect pressure in the system. Check that the pressure is correct. If the fault persists, contact an Authorised Service Centre.
How to fix a failed ignition shutdown on my Westen Boiler?
To address a failed ignition shutdown, press and hold down “R” for at least 2 seconds. If the problem continues, contact an Authorised Service Centre.
What to do if the safety thermostat tripped in my Westen Boiler?
If the safety thermostat has tripped, press and hold down “R” for at least 2 seconds. If the issue remains, contact an Authorised Service Centre.
What to do if my Westen Boiler shuts down after 6 consecutive flame losses?
If your boiler shuts down after 6 consecutive flame losses, press and hold down “R” for at least 2 seconds. If the fault continues, contact an Authorised Service Centre.
How do I resolve a parasite flame (flamer error) on my Westen Boiler?
To resolve a parasite flame error, press and hold down “R” for at least 2 seconds. If the problem persists, contact an Authorised Service Centre.
General| Mounting | Wall-mounted |
|---|---|
| ErP Heating | A |
| ErP Water | A |
| NOx Class | 5 |
| Fuel Type | Natural Gas |
Essential steps before installing the boiler for correct operation and warranty.
Checks and procedures to ensure safe and correct initial startup of the boiler.
Step-by-step guide to lighting and starting the boiler correctly for the first time.
Setting ambient/DHW temperatures and selecting operating modes (Summer, Winter, Heating Only, Off).
Procedures for filling the system, turning off the boiler, and gas type conversion.
Protecting from frost, resolving faults, and performing routine maintenance.
Overview for installers, connection types, safety, and system design.
Steps for mounting the boiler, connection points, and dimensional specifications.
Guidance on coaxial/separate flue/air duct installation and length limits.
Wiring power supply, safety devices, and connecting an external room thermostat.
Procedures for gas type conversion and configuring boiler parameters.
Visualizing boiler parameters, understanding safety features, and fault handling.
Steps for checking combustion, toxicity, and understanding pump capacity.
Connecting external components and performing annual servicing.
Procedures for filter cleaning, DHW descaling, and interpreting functional circuit diagrams.
Detailed wiring schematics and comprehensive technical specifications.
