Westen pulsar D User Manual

5
926.323.1 - GB
INSTRUCTIONS FOR USERS
4. ADJUSTING AMBIENT TEMPERATURE AND DHW TEMPERATURE
The system must be equipped with an ambient thermostat for controlling the room temperature.
Adjust the ambient temperature ( ) and the DHW temperature ( ) by pressing the respective +/- buttons (gure 1).
The ignition of the burner is shown on the display with the symbol ( ) as described in section 3.1.
HEATING
While the boiler is operating in heating mode, the display (gure 1) shows the ashing symbol ( ) and the heating de-
livery temperature (°C).
DOMESTIC HOT WATER
While the boiler is operating in DHW mode, the display (gure 1) shows the ashing symbol ( ) and the DHW output
temperature (°C).
Press this button to set the following boiler operating modes:
• SUMMER
• WINTER
• HEATING ONLY
• OFF
In SUMMER mode, the display shows ( ). The boiler satises requests for DHW only while central heating is NOT ena-
bled (ambient frost protection function active).
In WINTER mode, the display shows ( and ). The boiler satises requests for both DHW and central heating (am-
bient frost protection function active).
In HEATING ONLY mode, the display shows ( ). The boiler satises requests for central heating only (ambient frost
protection function active).
In OFF mode, the display shows neither of the above two symbols ( ) ( ). In this mode only the ambient frost pro-
tection function is enabled, any other request for DHW or heating is not satised.
5. DESCRIPTION OF BUTTON (Summer - Winter - Heating Only - Off)

Westen pulsar D Specifications

General

Brand	Westen
Model	pulsar D
Category	Boiler
Language	English