Lit. No. 27366, Rev. 01 February 15, 2008
27
SYSTEM OVERVIEW – CONTROLS
GENERAL INFORMATION
The MVP PLUS™ snowplow is
operated by with one of two special
controls—the CabCommand 9-button
hand-held control or a joystick-style
control. The controls allow you to go
from a vee, to a scoop, to a standard
straight-blade snowplow, all at the
touch of a button or single-lever
movement.
Each control has its own ON/OFF
switch with an indicator light to show
WARNING
To prevent accidental
movement of the blade, always
turn the ON/OFF switch to OFF
whenever the snowplow is not
in use. The control indicator
light will turn off.
when the control is powered up. Your
vehicle ignition (key) switch controls
a fused circuit that powers your cab
control directly from the battery.
The ON/OFF switch on the cab
control allows you to turn OFF the
control and prevent blade movement
even when the ignition switch is ON.
The control ON/OFF switch serves
as an emergency stop if required.
All controls are protected by a
replaceable fuse located in the under
hood snowplow electrical system.
See Fuse Replacement in the
Maintenance section of the Owner's
Manual.
The control is able to sense a lack of
communication with the electrical
system. Should the indicator light
start to flash, refer to the
Control/Cable/Plow Module Test.
MVP PLUS™
Joystick Control
MVP PLUS™
Hand-Held Control
Indicator Light
Indicator Light
ON/OFF Switch
(Emergency Stop)
To Next Page
Loading...
Need help?
General
