60 / 65
www.wireless-tek.com
Pic 65 RMON event group configuration page
18、Cluster configuration
（1）NDP configuration page
Figure 66 shows the NDP configuration page, where users can configure NDP.The
information that can be set includes: port selection, port NDP function, global NDP function,
NDP packet sending interval, and aging time of NDP packets on the receiving device.
Port selection, select the port as required, and enable the port NDP function. NDP must
run normally, and the NDP function of the global and port must be enabled at the same time.
Configure the aging time of the NDP packets sent by the device on the receiving device.
The effective time range is 1-4096 seconds. The default configuration is 180 seconds.
Configure the interval for sending NDP packets, the valid time range is 1-4096 seconds,
the default is 60 seconds.
Pic 66 NDP configuration page
（2）NTDP configuration page
Figure 67 shows the NTDP configuration page, where users can configure NTDP. The
information that can be set includes: Select port, enable port NTDP function, enable global
NTDP function, topology collection range, time topology collection interval, first port forwarding
packet delay time, and other port forwarding packets delay.
Port selection, you can select the port as required, and enable port NTDP function. NTDP
to run normally, you must also enable the global and port NTDP function.
To Next Page
Loading...
