Windhager FB 5210 - Verifying Setpoints; Solar System Performance Display

Operating instructions
Operation module FB 5210
15
4.3Checking set values
Release key . Through individual keystroke reach the set- and actual values
(measured values) to the display
. They could be at a maximum:
Pressing the button once returns the basic
dis
play into the display. This
comes about also automatically if no button is not pressed for a minute.
4.4Display of collector temperature and solar profits
If in a system there is a solar module installed, the collector temperature and
the solar profits can be asked so.
Release key . Through individual keystroke reach the set- and actual values
(measured values) to the display.
Pressing the button once returns the basic display into the display. This
comes about also automatically if no button is not pressed for a minute.
Boiler temperature set
Room temperature set
H
eating forward temperature set
Domestic hot water temperature set
Solar
profits
kWh
Collec
tor temperature °C
Pressing key permanently. The oper-
ation module announces after each other
the measured temperature levels.
If all measured values are passed, additional
appears, however instead of the main image,
the required values in the display.
Pressing the button permanently.
The operation module shows all measured
temperature values after each other.
If all measured values are passed, additional
appears, however instead of the main image,
the required values in the display.