EasyManuals Logo

Windsor Commodore 20 User Manual

Windsor Commodore 20
77 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
Maintenance
Service Schedule
Maintenance Daily Weekly Quarterly
Check machine for cord damage *
Check recovery dome and gasket for damage and cleanliness *
Check brush – should be clean with no lint or strings attached *
Inspect vac shoe for blockage; remove fibers with coat hanger, etc. *
Check hoses for wear, blockages, or damage *
Check handles, switches, and knobs for damage *
Check vac motor intake filter and clean *
Run one gallon of water through system *
Clean out recovery tank and check float valve to make sure it moves freely *
Clean out solution tank and remove and clean vacuum intake screen *
Clean outside of all tanks and check for damage *
Run vac motor for at least one minute to allow motor to dry *
Store with dome off tank to allow the tank to dry *
Check all bearings for noise *
Check all gaskets for wear and leakage *
Check vacuum intake screen for damage; replace if necessary *
Check pump pressure; observe spray pattern and check with gauge if
necessary
*
Check and clean solution screen *
Check belts for wear and replace as necessary *
Check brush for wear; ensure bristles are not damaged *
Check cables for fraying *
Check the spray bar (manifold) for damage; replace if broken or bent *
Check condition of vac shoe and frame for damage *
Check overall performance of machine *
Check vac motor carbon brushes *
86400940 Operators Manual - CMD20

Other manuals for Windsor Commodore 20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Windsor Commodore 20 and is the answer not in the manual?

Windsor Commodore 20 Specifications

General IconGeneral
Electrical230V, 8 A, 50 HZ
Power Cable75’ (23 m) (12 gauge)
Electric Propelling Motor(1) –1/4 hp DC (186 watts) with variable speed forward.
Electric Vacuum Motor(1) – 3 stage, 1 hp 99 cfm (2.80 m³/min.)
Drive SystemTransaxle unti variable speed Operating Speed: 0-100ft/min (30m/min)
Waterlift117” (297 cm)
Brush Speed1000 RPM
Solution Capacity20 Gallons (75 ltr)
Recovery Capacity20 Gallons (75 ltr)
Brush(1) 18” (45.8 cm)
Solution Pump100 psi (6.9 BAR), diaphragm style, demand pump
Solution Spray2 quick change jets
Vacuum Shoe22” (56 cm) wide, cast urethane floating and pivoting.
Wheels - Front (2) - Rear (2)4” dia. (10 cm) caster by 2.5” 10” dia (25 cm) wheels by 2”
Weight and Dimensions IconWeight and Dimensions
Dimensions - Weight215 lbs. (98 kg)
Dimensions - Length51” (130 cm)
Dimensions - Height44” (111 cm)
Dimensions - Width22” (56 cm)

Related product manuals