MULTI- ZONE / FROZEN FOOD VENDOR • 3576 • 4222618A | 9
AUTOMATIC DELIVERY LIFT
This information is for machines with the GVC2 Control Board (part number 4214682.004)
and software version V3.3.10177 and higher.
INTRODUCTION
The Automatic Delivery Lift system is designed to lift vended products to the 2012
American Disabilities Act (ADA) height requirement level from the locations floor. This
same system can also provide an enhanced customer experience for those locations
where an almost hands free vended product presentation is desirable.
The Delivery Lift system is an option that can be used on the line of Delivery Lift Ready
Machines (also called ADA ready machines) and consists of an LED illuminated product
delivery box with a motorized product lift plate, a set of product height sensors, a motorized
delivery box door (Auto Door) and a Blue LED illuminated activation button.
The delivery lift system can be factory installed or provided as a retrofit kit for field ADA
ready machines. See the list of ADA ready model numbers or contact a sales or service
representative for more information.
INITIAL SETUP – SERVICE MODE
When an Automatic Delivery Lift system is installed in an ADA ready machine, it is
automatically detected when a controller Service Mode Motor Count is done. The Motor
Count will show the tray motor count briefly with the 3 additional delivery lift motors before
returning to a tray motor count only. Once a Delivery Lift system is detected, it will complete
a functional test at every Motor Count or at machine power on. When the Delivery Lift is
moving, the Blue Delivery Lift Button on the front of the machine will flash and can be
pressed to stop the Delivery Lift operation if necessary. Information on Service Mode
Configuration menu and Diagnostic Mode menu options are listed on the following pages.
SALES MODE
When a product is selected and vended, the product drops into the Delivery Lift Box after it
first passes by the iVend sensor to confirm that a product has been vended. Next, when the
machine is using the default BUTTON configuration mode, the Blue Delivery Lift Button will
be constantly illuminated for 10 seconds, during this period the Delivery Lift can be
activated. When the illuminated button is pressed, the Delivery Door will open, the Delivery
Lift will begin raising the vended product and the button will flash. The product will be
raised until a portion of the product package blocks the Delivery Lift sensors, indicating that
the product has reached the ADA delivery height. The machine display will now show
“Please Remove Your Product” and an audible beep will occur every 10 seconds until the
product is removed or one minute has elapsed. After one minute, the Delivery Door will
close and the “Please Remove Your Product” message will continue to be displayed. Once
the product is removed and the Delivery Lift Sensors are no longer blocked, the Delivery
Lift will return to the bottom of the Delivery Box and machine display will return to the sales
mode message and is ready for the next vend.
NOTE: If a customer grabs the product while the Delivery Lift is in operation, the Delivery
Lift Sensors may detect a sensor blockage and will stop the Delivery Lift at its current
location. Pressing the flashing Blue Delivery Lift Button will also stop the Delivery Lift.
SERVICE MODE PROGRAMMING & TEST FUNCTIONS
Once in the service mode the control functions can be accessed and used, these are the
service menus specific to the Automatic Delivery Lift functions.
• Service Mode 2 – Motor Count
To Next Page
Loading...