WMF 1500 S+ - Clean the Mixer

101
User Manual WMF1500S +
Care | Manual cleaning
5.5.9 Clean the mixer
Cleaning will be more frequent depending on powder
consumption.
Scalding hazard
• If the mixer hose is not firmly attached,
hot water or hot powder beverage can be
discharged inadvertently.
> Always install the mixer hose firmly.
 Slide the operating panel upward
 Pull the mixer hose off of the combi spout and use
the handle to move the mixer bowl upward
The propeller for the mixer is now visible.
Daily
 Remove the mixer bowl
 Disassemble the mixer bowl into its four component
parts
 Thoroughly clean the parts under running drinking
water
When needed (weekly)
 Mix 5ml of WMFspecial cleaner or aspecial
cleaning tablet with 500ml of warm drinking water
 Immerse all four parts in the cleaning solution at
least for 4hours
 After 4hours, thoroughly rinse under running
drinking water again
 Remove the powder hopper and clean the loading
chute to the mixer bowl with acloth or brush
 Allow the parts to dry completely[1]
On re-assembly, all openings must face in the
same direction.
 Insert the propeller part[2] as shown in the
illustration
The green side should be visible after insertion.
 Attach mixer hose on the mixer bowl
 Replace mixer bowl until it engages in the lock
 Attach mixer hose on the combi spout
CAUTION
Follow the Safety chapter
w starting on page 7
Instructions
w Main menu
w Care
w Instructions
1
2