WMF 1500 S+ - Enable Milk System; FFC Filter Change; Foamer Rinsing; Cleanlock

42
User Manual WMF1500S +
Software | Care
Enable milk system
During cleaning, the system asks whether milk
beverages should be enabled after cleaning. If “no”
is selected, then only beverages without milk will be
available afterward.
“Enable milk system” means that milk beverages will be
available again.
FFC filter change
Replace the filter after 100brewing cycles / 72hours.
 Touch FFC lter change
The display-guided instructions are launched.
 Follow the instructions on the display
This pad can also be used to indicate how many more
beverages can be dispensed with the current filter and
when to next perform system cleaning with FFC.
Foamer rinsing
Foamer rinsing is an intermediate cleaning process for
the milk foamer.
CleanLock
 Touch CleanLock
A 15-second countdown starts.
The touch display can now be cleaned.
The touch display is activated again 15seconds after
the last time it was touched.
Enable milk system
DS_04_03_04
DS_04_03_10
FFC lter change
FFC filter change
w Care
page 86
Foamer rinsing
DS_04_03_05
Foamer rinsing
w Care
page 86
CleanLock
DS_04_03_06
Clean the operating panel
w Care
starting on page 93