15
User Manual WMF1500S +
Safety
Installation location
• The device can be used as aself-service device if it is supervised
by trained personnel.
The machine must be set up so as to allow good visual access.
•
The device must be placed and levelled on ahorizontal, sturdy,
water-resistant, and heatproof base.
• The device must not be cleaned using awater jet. The device
must be installed where it is protected against water spray.
• The device must not be located on asurface that is sprayed or
cleaned with awater hose, steam jet, steam cleaner, or similar
devices.
Water supply
• 3/8inch hose connector with water mains tap, and dirt filter
with 0.08mm mesh size, on site. At least 0.2MPa (2bar) supply
pressure at 2l/min. Maximum 0.6MPa (6bar). Maximum inlet
temperature 35°C.
• The set of hoses provided with the new coffee machine
and/or the new water filter must be used. Do not use the old
set of hoses.
Ambient temperature
• Ambient temperature +5°C to amaximum of +35°C