WMF 5000S+ - Enable Milk System; Foamer Rinsing; Cleanlock; Instructions

39
User Manual WMF5000 S +
Software | Care
Enable milk system
During cleaning, the system asks whether milk
beverages should be enabled after cleaning. If “no”
is selected, then only beverages without milk will be
available afterward.
“Enable milk system” means that milk beverages will be
available again.
Foamer rinsing
Foamer rinsing is an intermediate cleaning process for
the milk foamer.
CleanLock
 Touch CleanLock
A 15-second countdown starts.
The touch display can now be cleaned.
The touch display is activated again 15seconds after
the last time it was touched.
Instructions
Animated instructions about the available cleaning
programs and for installing and removing the mixer
and combi spout for cleaning.
Filling the milk system (DynamicMilk)
This function fills the milk system for dispensing cold
beverages.
 Touch Milk system rell
Drip tray cleaning
The combi spout moves upward when the “Drip tray
cleaning” pad is touched. The drip tray can then be
cleaned.
Enable milk system
DS_04_03_04
Foamer rinsing
DS_04_03_05
Foamer rinsing
w Care
page 77
CleanLock
DS_04_03_06
Clean the operating panel
w Care
page 78
Instructions
DS_04_03_07
Milk system rell
DS_04_03_08
Drip tray cleaning
DS_04_03_09
Clean drip tray
w Care
page 79