99
2. The display asks you to put in the ground coffee.
3. Open the manual input 3. Take the measuring spoon
(order no. 33.0724.4000) and pour in the appropriate
quantity of ground coffee (max. 25g) for the quantity to
be brewed. Then close the manual input 3.
4. After closing the manual input, press the appropriate
beverage key on the control panel.
5. The beverage selected is prepared using the ground
coffee put in. The display shows the name of the coffee
beverage selected and the progress of brewing in the
form of a filling cup. Quantity pre-selection is not pos-
sible in this mode.
6. At the end of the brewing process the freshly prepared
coffee beverage is ready. The used coffee grouts are
collected in the built-in coffee grouts collector 12. All
the key lights are reactivated again and the display
shows the “Ready” message. The machine is ready for
the next brewing operation.
7. If no beverage keys are pressed within 40 seconds of
unlocking the manual input 3, the ground coffee that
was put in is ejected into the grouts collector and the
machine is ready for operation again.
3
To Next Page
Loading...
Need help?
General
