120
8.2.6 Addition of milk
To set or alter the setting for adding milk to a coffee bever-
age, enter the beverage settings menu (see chapter 8.2 on
page 115), choose the setting mode for the beverage se-
lected and use the and/or soft keys to scroll to the
setting page where the Addition Milk soft key appears. Then
press the Addition Milk soft key.
The following display appears. You can now choose
whether you wish to add no milk None, milk Milk, froth Foam
or milk & froth Milk&Foam to the coffee beverage.
Caution! Scalding hazard!
In the dispensing area for coffee 7, hot water 11 and
steam 8 there is a scalding hazard.
In the example shown here, milk & froth Milk&Foam was
selected. By pressing the Test soft key at any time during
setting, you can activate milk or milk froth portioning to
check the result of the changes you have made to the set-
tings. Press the soft key to accept the new settings, or
press to quit the settings menu without accepting the
changes.
8.2.7 Beverage preparation sequence
To set or alter the sequence in which the individual bever-
age ingredients are prepared, enter the beverage settings
menu (see chapter 8.2, page 115), choose the setting mode
for the beverage selected and use the and/or soft keys
to scroll to the setting page where the Sequence soft key
appears. Then press the Sequence soft key.
The following display appears. Press the and/or
soft keys to select the sequence in which the Coffee, Milk
and Foam steps take place during preparation.
To Next Page
Loading...
Need help?
General
