To Next Page

To Previous Page

PAGE 17

RTD TESTING

First access Diagnostic Mode. Once in Diagnostic Mode, the RTD

temperature as read by the Oven Controller is shown in the corre-

sponding display.

NOTE: Diagnostic Mode will end 2 minutes after the last key stroke

or when the CLEAR key is pressed.

PROBE TESTING

First access Diagnostic Mode. Once in diagnostic Mode, the Probe

temperature as read by the Oven Controller is shown in the Stop

Cook digits in the corresponding display. If the Probe has not been

inserted, “0” will be shown as the Probe temperature. If the Probe

has not been completely inserted creating a short circuit of the Probe,

“998” will be shown as the Probe temperature.

Wolf e Series Information Booklet

Other manuals for Wolf e Series