PAGE 42
ELECTRIC COOKTOPS
DIAGNOSTIC MODE
Diagnostic mode allows the Service Technician to inspect the func-
tions of the cooktop controls. In diagnostic mode the last eight error
codes that have been recorded by the cooktop control can be
accessed. A total of 15 different modes can be accessed, once diag-
nostic mode has been initiated.
Initiating Different Modes
To initiate diagnostic mode, the unit needs to be in the “LOCK”
mode. Then, press and hold the “OFF” keypad for 5 seconds. The
cooktop controls will now enter into diagnostic Mode 1.
NOTE: If the “OFF” keypad is not released after 7 seconds, the diag-
nostic mode will be cancelled and the unit will return to the “OFF”
mode.
NOTE: If any other input signals are detected from the keypad, the
unit will not enter diagnostic mode.
NOTE: When in diagnostic mode all heating units are off.
NOTE: The unit will exit diagnostic mode if no inputs are detected
from the keypad in 20 seconds.
NOTE: If the “OFF” keypad is pressed again anywhere within the
diagnostic program, the unit returns to the “LOCK” mode of operation.
NOTE: There will be no audible signals during the diagnostic mode.
To Next Page
Loading...
