SETUP & OPERATION
Mounting the Moulding Knives
Operation EGdoc042320 4-12
4
2. Clean thoroughly any dust, chips and debris from the cutter socket, the clamping wedges and the
knives. Remove the springs from the holes in the cutter. Screw in the bolts of the clamping wedges
and assemble the knives to the clamping wedges as shown below.
3. Carefully insert the knives with the clamping wedges in the cutter socket as shown below.
FIG. 4-11
FIG. 4-12
To Next Page
Loading...
