SETUP & OPERATION
Mounting the Moulding Knives
4
4-13 EGdoc042320 Operation
4. Tighten the bolts of the clamping wedges. Be sure that the knives are touching each other.
5. Mount the three remaining sets of knives in the same way. Be sure that they are mounted exactly in
the same position on the cutter - see the figure below.
DANGER! Make sure that all mounted knives are aligned identically.
If they are not, it will cause vibrations of the cutter and may result in
personal injury.
FIG. 4-13
FIG. 4-14
To Next Page
Loading...
