SETWORKS OPERATION
Start-up settings of the controller
5
5-3 EGdoc042320 SETWORKS OPERATION
See Pic. 5-2.
Press to save the entered divider value.
1. Auto-calibration
This function should be used in case of: replacement of any component of the cutter height setting
system, motor or after lubrication of the up/down screw and other moving elements or when significant
cutter height setting variances are observed.
Switch on the moulder by turning the main switch to the ON position and wait until the inscription
“MPS-01” disappears.
Using buttons, set the cutter at the height of 200 mm.
Press and hold down . After a while - the message “Auto CALL” will appear on the displays.
The controller is ready for auto-calibration.
PIC. 5-2
To Next Page
Loading...
