SETWORKS OPERATION
Start-up settings of the controller
SETWORKS OPERATION EGdoc042320 5-4
5
See Pic. 5-3.
Press again, the controller successively performs some movements of the cutter.
After performing the last movement, the controller is ready for operation.
2. Real cutter height entering
To ensure that the upper display shows the correct cutter height, it is necessary to enter the real cutter
height. It must be done at the first start-up and also when:
- significant cutter height setting variances are observed;
- a sudden power disappearance occurs while the controller is setting the cutter height;
- any repairs to the up/down system were made.
To enter the real cutter height:
Press and hold ,
Move the cutter to an even measurement on the scale (e.g. to 250mm),
Measure the distance between the bottom knife and the moulder bed and make sure that the scale
shows the same distance. If not, See Section 4.1
for the alignment instructions.
PIC. 5-3
To Next Page
Loading...
