Wood-mizer MP100 Series - Page 93

MAINTENANCE
Safety Devices Inspection
MAINTENANCE 15doc042320 6-12
6
 Release the safety handle. Measure the cutter braking time. It should be shorter than
10 seconds;
1
 Start the motor again;
 Turn the key switch to the “0” position. Measure the cutter braking time. It should be shorter
than 10 seconds;
 Start the motor again;
 Turn the key switch to the “H” position. Measure the cutter braking time. It should be shorter
than 10 seconds.
1. It doesn’t concern US version.