SPECIFICATIONS
Moulder Specifications
Specifications EGdoc042320 7-4
7
See Table 7-6. The noise level of the MP100/150 moulder is given below.
1
2
3
See Table 7-7. See the table below for planing/moulding material specifications.
See Table 7-8. Other specifications of the moulder are listed below.
Equivalent Noise Level
Under Load
MP100/150 Moulder
Equipped With E5 Electric Motor
L
pA
= 87dB (A)
TABLE 7-6
1. The noise level measurement was taken in accordance with PN-EN ISO 3746 Standard. Value for associated
uncertainty K=4dB.
2. The measured values refer to emission levels, not necessarily to noise levels in the workplace. Although there is
a relation between emission levels and exposure levels, it is not possible to determine with certainty if preventives
are needed or are not needed. The factors affecting a current level of noise exposure during work are inter alia
room characteristics and characteristics of other noise sources, e.g. number of machines and machining
operations nearby. Also, the permissible exposure level value may vary depending on country. This information
enables the machine’s user to better identify hazards and a risk.
3. IMPORTANT! The total value of hand-arm vibration the operator may be exposed to does not exceed 2.5 m/s2.
The highest root mean square value of weighted acceleration to which the whole operator’s body is subjected does
not exceed 0.5 m/s2.
Minimum Cant Height 60 mm (2.362”)
Maximum Cant Height 600 mm (23.62”)
Maximum Cant Width
1
1
Using horizontal adjustment
520 mm (20.47”)
TABLE 7-7
Cutter Specifications
Number of Knife Sockets 4
Cutter Diameter 122 mm (4.8”)
Cutter Width 410 mm (16.14”)
Cutter Horizontal Adjustment 110 mm (4.33”)
Cutter Rotations 4890 rpm
Specifications of Knives
Straight Knife Height “A” 27-35 mm (1.063 -
1.378”)
Straight Knife Thickness “B” 2-3 mm (0.079 - 0.118”)
Straight Knife Protrusion “C” 1.1 mm (0.043”)
Pattern Knife Thickness “B” 3-5 mm (0.118-0.197”)
TABLE 7-8
To Next Page
Loading...
