Worcester GB162-100

INSPECTION
6 720 648 726 (2011/07)
63
12.12 INSPECTION LOG BOOK
B Enter your signature and the date after completing the inspection activities.
Inspection activities Date: ________ Date: ________ Date: ________
1. Checking the general condition of
the heating system.
 
2. Carrying out a visual inspection and
function test of the heating system.
 
3. Checking the gas and water-bearing
system components for:
• Operational tightness
• Visible corrosion
• Signs of wear.
Section 10.2.8,
page 54.
Section 12.3,
page 61.
 
4. Measuring the ionisation current. Section 10.2.11,
page 55.
___________ μA ___________ μA ___________ μA
5. Measuring the gas supply pressure
(working pressure).
Section 10.2.6,
page 51.
________ mbar ________ mbar ________ mbar
6. Checking the gas/air-ratio. Section 10.2.7,
page 51.
_________ Pa _________ Pa _________ Pa
7. Carrying out a tightness check of the
gas circuit in operating conditions.
Section 10.2.8,
page 54.
 
8. Measuring the carbon monoxide
content (CO), air free.
Section 10.2.9,
page 55.
_________ ppm _________ ppm _________ ppm
9. Checking the system pressure.
• Pre-pressure of expansion vessel
(also see installation instructions
for expansion vessel)
• Filling pressure.
Section 10.1,
page 47.

_________ bar
_________ bar

_________ bar
_________ bar

_________ bar
_________ bar
10. Checking the operation and safety of
the air intake and flue gas pipe.
Section 10.2.4,
page 51.
 
11. Checking the boiler settings of the
control device (in accordance with
requirements).
See the
documents for
the control
device.
 
12. Final check of the inspection
activities, documenting the
measurement and test results.
 
13. Confirming proper inspection.
Company
stamp/
signature/
date
Company
stamp/
signature/
date
Company
stamp/
signature/
date
Table 20