8
Motor
Be sure your power supply agrees with nameplate marking. 230 Volts AC only
means your tool will operate on standard 50 Hz household power. Do not operate
AC tools on DC. This information is printed on the nameplate. Lower voltage will
cause loss of power and can result in over-heating.
Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the correct
size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord.
SAVE THESE INSTRUCTIONS
Minimum Gauge for Cord Sets
Volt Total Length of Cord in Feet
120V 0 - 25
(0-7.6 m)
26 - 50
(7.6-15.2 m)
51 - 100
(15.2-30.4 m)
101 - 150
(30.4-45.7 m)
230V 0 - 50
(0-15.2 m)
51-100
(15.2-30.4 m)
101-200
(30.4-60.9 m)
201-300
(60.9-91.4 m)
Ampere Rating
American Wire Gauge
More Than Not More Than
0 6 18 16 16 14
6 10 18161412
10 12 16 16 14 12
12 16 14 12 Not Recommended
Noise and Vibration Measurements:
Noise (measured values per EN 60745-1 and EN 60745-2-4)
A-weighted sound pressure level Lpa ........................................................................73 db(A)
Uncertainty factor K....................................................................................................3 db(A)
A-weighted sound power level Lwa ..........................................................................84 db(A)
Uncertainty factor K....................................................................................................3 db(A)
Intended Uses:
• Grinding, Sharpening and Honing applications on knives and tools.
• Light duty grinding in metal.
• Only for use with consumer applications.
• Tool should only be used with sharpening cassette installed.
Unintended Uses:
• Industrial or commercial grinding or sharpening applications.
• Extended, continuous heavy duty use.
To Next Page
Loading...
