EasyManua.ls Logo

World Cat 280DC-X - 6.11 Engine; Gauges; 6.12 Plumbing System

Default Icon
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2020 World Cat 280DC-X Owner’s Manual
32
6.10.12 Marine Head Switch
The marine head is powered by the fuse panel, and the head switch is located at the
outboard side of the head. The control switch operates a ll and / or ush funcon. A
macerator pump is incorporated into the head. The macerator pump is operated o the
mechanical switches in the dash.
6.10.13 Anchor Windlass
The windlass is used to deploy and retrieve the anchor. This accessory is controlled by a switch at the helm,
and can also be controlled at the bow with up and down switches located in the starboard bow anchor
locker. The windlass breaker is located on the baery management panel.
The 280DC-X integrated windlass system is made possible by an advanced feed system for the anchor rode.
Once entering the bow of the boat, the anchor rode is routed to the starboard side of the boat into a hidden
windlass. Extra care must be taken to ensure the anchor rode feeds into the system without knots or debris.
The feed of the anchor rode in or out of the system should be monitored any me the system is in use.
!!! CAUTION
When operang the windlass, extra care must be taken to keep hands free of situaons where the
rode could catch and restrict movement.
6.10.14 Fusion
®
Marine Entertainment System MS-RA70N
Similar to an automove stereo, the unit can be operated using the faceplate. It is
powered by the fuse block, and the memory wire is connected to a 24 hour circuit.
6.10.15 Windshield Wiper
The wiper is operated by a dedicated wiper switch on the main dash. The wiper funcons idencally to those
found on passenger automobiles.
6.10.16 Horn
Funcons idencally to those found on passenger automobiles and is operated by a red push buon switch
on the main dash panel.
6.10.17 Accessory Switches
The accessory switches are located on the dash panel. “ACC 1” is usually reserved for the underwater lights
installed at the factory. The remaining “ACC” switches can be used to operate aermarket products. Be
aware of the power requirements for any add-on products so you do not exceed the capacity of the breaker
supplying the switch. Failure to do so could damage the appliance and / or the electrical system.
6.10.18 Power Steering
The power assist unit provides automobile-like steering on your catamaran. The unit is installed
in the console between the helm and steering rams. The power for the unit is connected to the
port and starboard key switch. If you should decide to troll with one engine, your power assist
will sll be operaonal.

Table of Contents

Related product manuals