page 54 of 84
D SOFTWARE FOR THE DEFINITION OF MACHINE TOOL GEOMETRY
MACHINE TOOL INSPECTION SOFTWARE MT-SOFT
MT-SOF gives the possibility to measure individual elements of machine tools with standard inclination measuring
instruments. The measured results can be saved and at a later stage used for comparison and put together to
receive a thorough result of the over all accuracy of the machine tool. E.g. the horizontal guideway must be
compared to the vertical axis of the spindle. Only when the measurement is done in absolute mode such a
comparison is possible. The logical and clear structure of the software makes even the measurement of complex
machines an easy task.
The following measurement tasks can be done by
using suitable instruments and the WYLER MT-SOFT:
• G
UIDE WAYS
• R
OTATING AXIS
• R
OTATION OF MACHINE TOOL ELEMENTS
• C
IRCLES
G
UIDE WAYS
Measurement of guide ways using inclination
measuring instruments
ROTATING AXIS
Definition of rectangularity between the surface of the
table and the vertical rotating spindle
ROTATION OF MACHINE TOOL ELEMENTS
Measuring and defining the geometrical roll and pitch
errors on a machine tool element moving horizontally
CIRCLES
Flatness measurement and defining the position in
space of circles as well as co planarity of circles.
To Next Page
Loading...
