page 58 of 84
G SPECIAL FUNCTIONS
G1 R
ESET TO FACTORY PRE-SETTINGS
You can reset all adjustments and settings to the factory pre-settings. For this action press simultaneously the keys
<ENTER> and <ON/MODE> until an arrow to the right hand side appears in the display.
The following values will be set and the following actions performed:
BlueMETER:
• Filter Type 3
• Unit mm/m
• Display mode Absolute
• Relative Base in millimetres, value 1000
• Relative Base in Inch, value 10
• All members of the wireless data transmission group are deleted
• All members of the list of instruments are deleted
BlueLEVEL
• Filter Type 3
• Unit set to
o 1μ instrument: mm/m, 3 decimals
o 5μ instrument: mm/m, 3 decimals, rounded to 5µm/m
o 10μ instrument: mm/m, 2 decimals
• Display mode Absolute
• Relative Base in millimetre, value 1000
• Relative Base in Inch, value 10
• All members of the wireless data transmission group are deleted
• Relative Zero is set to 0
• Absolute Zero is set to 0
G2 FIRMWARE VERSION
With a special key operation you can read the version number of the firmware installed. After turning off the
instrument hold the <ON/MODE> key down for another 10 seconds.
The display shows in large figures the date of issue and at the bottom the version number of the firmware.
To Next Page
