97-0019-01-01 13
Freedom SW Inverter/Charger Mechanical Features
7 CLEAR FAULT RESET button is used to clear any
active faults if pressed momentarily. If held down for
more than three seconds, the unit will reset (reboot)
itself.
8 STACKING port is used to connect two inverter/
chargers together for stacked operation. This is required
only for stacking in series.
9 XANBUS INTERFACE ports are used to connect
Xanbus-enabled devices including the optional SCP and
AGS.
Item Description
FSW Owners Guide.book Page 13 Tuesday, August 7, 2018 9:03 AM
To Next Page
Loading...
