70 Freedom SW Owner’s Guide
Configuring the Freedom SW using the SCP
Setting the Device Name
The Dev Name setting allows you to customize the name of
the Freedom SW as it is displayed on other screens and
menus.
Changing the device name is not mandatory for stacking to be
successful. It simply allows a user to distinguish between two
inverter/chargers that are installed in the same system.
The available characters are:
• A to Z
• a to z
• 0 to 9
• space
Some examples of names are: “Master”, “Slave”, “Main”, and
“Secondary”.
To customize the Freedom SW name:
1. On the device setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced
Settings on the device setup menu, display Advanced
Settings by pressing Enter + Up arrow + Down arrow
at the same time.
2. Select the Stacking menu.
3. Select Dev Name.
4. Press Enter.
The last letter of the Freedom SW name is highlighted.
5. Begin customizing the device name.
• To change the character, press the up or down arrow
button. Holding down the button causes the characters to
scroll more quickly.
• To delete the character, press Func.
• To add characters, press Enter.
6. When the correct character is shown, press Enter to
select it.
7. After pressing Enter to select the last character of your
customized device name, press Enter again to return to
the menu.
NOTE: Increasing the number of characters in a device name may cause
other text on the same line to run off the edge of the screen. Device names
should be limited to 10 characters or less.
FSW Owners Guide.book Page 70 Tuesday, August 7, 2018 9:03 AM
To Next Page
Loading...
Need help?
General
