XCT80 Truck Crane Operation Manual
7-6
7-2 Operation of lower crane
portion engine
7-2-1 Check before starting the engine
1. Check hydraulic system stop valve
The stop valve is located in the right side
of the hydraulic tank, and must be opened
before engine start. When the lever is parallel to
the pipeline, it indicates the valve is open.
2. Turn on the main power switch
The power supply main switch is located
on the vehicle shed in the right side and hood
middle position, turning to the right to turn on
the power supply main switch, and to the left to
turn off the power supply main switch.
3. Check coolant
Coolant tank is located in the rear left of
the lower crane portion cab.，in Figure 7-4.
Figure 7-3 the main power switch
●There is danger of getting burned in
the engine overheating.
●The coolant is sealed. Pay attention
to the steam from the port which may cause
burns if the cooler is opened when the engine
is very hot.。
Please wear suitable protective gloves before
opening the lid.Screw slowly the lid to the first
notch to let steam release.
Traveling Status on Highway
Chapter 7
To Next Page
Loading...
