XCT80 Truck Crane Operation Manual
9-1
Chapter 9 Crane accessory
a. In the installation and removal of fast
plug connector of auxiliary winch, you should
pay attention to the protection of the O-ring.
b. In the installation and removal of auxiliary
winch, you should pay attention to the lifting
position, and try to ensure that the spreader is just
above the lifting point of the auxiliary winch, to
avoid inclined pulling.
c. The vehicle performance table is given
in the case of configuration with auxiliary
winch. When the auxiliary winch is dismantled,
Aiming at stability conditions below
the dividing line in the performance table,
the lifting weight of the auxiliary winch is
prohibited to remove.
Crane accessory
Chapter 9
9-1 Crane accessory selection
9-2 Mounting and dismounting of
auxiliary lifting mechanism
9-2-1 Operating Precautions
Some risks exist in process of assembly,
inst al la tion, ope ra ti on , disas se mb ly an d
transportation of crane. The producers do
not responsible for accidents caused by the
operation of crane not in accordance with the
laws and regulations and the crane operating
conditions and procedures. Please take a note
that the accident may result in casualties and
also will bring losses of mounts of goods and
materials. Please be sure to obey laws and
regulations and the operation guide. In this way,
you not only ensure your own safety, but also
ensure the surrounding personnel security.
it is equivalent balance weight decrease of
approximately 0.6t.。
d. In installation of the auxiliary winch,
you should pay attention to the installation
sequence of the pin, the lower 2 pin axles
should
be firstly installed, and then install the top pin.
The sequence is opposite when dismantling.
To Next Page
Loading...
