Problem Solving
7-56 Xerox 4112/4127 EPS
User Guide
3. Hold the tabs of the booklet staple cartridge and then lift to remove it.
4. Remove the jammed staples as shown in the illustration.
5. Holding the tabs of the booklet staple cartridge, return the cartridge to the original position
and gently push it until it clicks into place.
6. Return the unit to its original position.
7. Close the Finisher right cover completely. The machine will not operate if the cover is open
even slightly.
Note
If the staples cannot be removed after carrying out the above procedures, contact the
Customer Support Center.
WARNING
Be careful when removing jammed staples to avoid cutting and hurting your fingers.
To Next Page
Loading...
Need help?
General