Paper and other Media
2-14 Xerox 4112/4127 EPS
User Guide
Change/Confirm the Tray Settings
If you change paper types, the tray settings must be modified to reflect the paper type that is
loaded in the tray. The following describes how to change or confirm the attributes of the paper
loaded in the trays.
Change/confirm the tray settings from the All Services screen
Note
User Interface (UI) screens vary from system to system and from marketplace to
marketplace. As a result, the UI screens shown in this section may or may not reflect your
system configuration.
You can confirm and/or change the paper settings, such as weight, size, type, etc.
KeyPoint
In order for the user to confirm or change paper settings, the System Administrator must
enable the Paper Tray Attributes feature. See your System Administrator, or refer to the
System Administration Guide, Chapter 8, “Setup Menu.”
1. Press the Machine Status button on the Controller.
2. From the Machine Status menu, select the:
a. Tools tab
b. Paper Tray Attributes button
To Next Page
Loading...
Need help?
General