CentreWare
®
Internet Services
Xerox® Phaser® 3020
User Guide
17
•Automatic
• 10 Mbps (Half Duplex)
• 10 Mbps (Full Duplex)
• 100 Mbps (Half Duplex)
• 100 Mbps (Full Duplex)
8. Select on Apply to save the changes.
The change to Ethernet Speed rate will take effect after System Reboot screen appears.
9. Select OK.
10. When the Acknowledgement screen displays, select OK.
11. Reboot the machine.
Adjusting the Altitude
Print quality is affected by atmospheric pressure, which is determined by the height of the machine
above sea level. The following information will guide you on how to set your machine for the best print
quality.
Wi-Fi must be configured before you adjust the altitude. See Wireless Setting Program.
Before you set the altitude value, determine the altitude where you are.
1. Enter the IP Address of the printer in the browser.
2. Select Login and enter the ID (admin) and Password (1111).
3. Select Properties > System > Setup.
4. Select an Altitude Adjustment value, based on your altitude in the table above.
5. Select Apply.
Altitude Value
0 - 1000 M
0 - 3,280 ft.
Normal
1000 - 2000 M
3,280 - 6,561 ft.
High 1
2000 - 3000 M
6,561 - 9,842 ft.
High 2
3000 - 4000 M
9,842 - 13,123 ft.
High 3
4000 - 5000 M
13,123 - 16,404 ft.
High 4
To Next Page
Loading...
