SNMPv3
Xerox® Phaser® 3020
User Guide
75
SNMPv3
SNMPv3 can be enabled to create an encrypted channel for secure machine management.
1. At your workstation, open the Web browser and enter the IP Address of the machine in the
Address Bar.
2. Press Enter.
3. Select the Properties icon.
4. If prompted, enter the Administrator User Name (admin) and Password (1111), and select Login.
Select Properties.
5. In Network Settings select the SNMP.
6. Select SNMPv3. The SNMPv3 page displays.
7. In the Setup area:
a. Select the Enable check box to enable SNMPv3 Protocol.
b. In the Authentication area, enter the required User Name.
c. Enter a password in the Authentication Password field.
d. Enter the password again in the Confirm Password field.
e. For Authentication Algorithm, select either MD5 or SHA.
f. Enter a password in the Privacy Password field.
g. Enter the password in the Confirm Password field.
h. The Privacy Algorithm displays.
8. Select Apply to save the changes.
9. Select OK when the acknowledgement message displays.
To Next Page
Loading...
