Xerox Phaser 3117 - Page 67

Disassembly and Reassembly
x
Service Manual
5-7
5.2.7 RX Drive
1.Before Disassembling
-Separate the font cover.(Refer to 5.2)
-Separate the SMPS cover.(Refer to 5.3)
-Separate the Main cover.(Refer to 5.4)
2.Release 2 screws (Screw x 2:Silver_M3,6001-
000130)connected to the engine shield and 6 screws
(Screw x 6:Gold_M3,6003-000296)connected to the
frame. Separate the RX drive by pulling it out toward
the arrow direction.
3.Remove the connector from the separated RX drive. 4.After removing the RX drive,RDCN Gear, OPC Gear,
Fuser Gear, and Feed Gear can be removed from
the frame.
RX Drive
RDCN Gear
OPC Gear
Fuser Gear
Feed Gear
Please, be careful not to touch the protruding 4 screws at the
outside of the RX drive.
Note: