2.5 <
System setup>
Emulation menu
Use the Emulation menu to configure printer language emulation.
Job Timeout
You can set the length of time the printer waits
before printing the last page of a print job that
does not end with a command to print the page.
The default is 15 sec.
When a print time-out occurs, the printer prints
the page in the print buffer.
Maintenance This item allows you to maintain your printer.
• Clean Drum: Cleans the OPC drum of the
cartridge and produces a cleaning sheet with
toner debris on it.
• Clean Fuser: Cleans the fuser unit inside of
the printer and produces a cleaning sheet
with toner debris on it.
• Supplies Life: This item allows you to check
how many pages have printed and how much
toner is left in the cartridge.
Clear Setting This menu item allows you to restore the
printer’s factory default settings.
Item Explanation
Emulation
Type
The printer language defines how the computer
communicates with the printer.
If you select Auto, your printer can change the
printer language automatically.
Setup
See the tables on page 2.5 to configure the printer
language.
Item Explanation
Values: 0 ~ 1800 sec
Values: Auto, PCL, EPSON, PostScript, IBM
Values: PCL, PostScript, EPSON
PCL
This menu sets the PCL emulation configuration. You can set the font
type, symbol type, lines per page, and point size.
Item Explanation
Typeface
You can select the standard font to be used in PCL
emulation.
• PCL 1~PCL 7’s interval between letters is fixed, and
PCL 8~PCL 45’s interval is proportional to the font
type and point size. You can adjust the font size of
PCL 1~PCL 7 using the Pitch item, and
PCL 8~PCL 45 can do using Point Size item.
• PCL 46~PCL 54’s interval and point size are fixed.
Symbol
This item selects the symbol to be used in PCL
emulation. The symbol is the group of numbers,
marks, and special signs being used when printing
letters. The default is PC8.
Point Size
When you select one between PCL 8 and PCL 45 from
the Typeface menu, you can determine the font size
by setting the height of the characters in the font. The
default is 12.00.
Courier
This item lets you select the version of Courier font to
use.
Pitch
When you select a font between PCL 1 and PCL 7
from the Typeface menu, you can determine the font
size by setting the number of characters that will print
in one horizontal inch of type. The default value, 10 is
the best size.
Lines
This item allows you to set vertical spacing from 5 to
128 lines for the default paper size. The lines may
differ according to the paper size and printing
orientation.
Values: PCL 1 ~ PCL 54
Values: ROMAN8 ~ PCYRIL
Values: 4.00 ~ 999.75 (0.25 unit)
Values: Regular, Dark
Values: 0.44 ~ 99.99 (0.01 unit)
Values: 5 ~ 128 (1 unit)
To Next Page
Loading...
Need help?
General
