Security
Phaser 4622
System Administrator Guide
96
Trap Destination Addresses
You can specify Trap Destination Addresses.
1. In the Trap Destination Addresses area click Add IP Address.
2. Enter the IP Address and UDP Port Number in the IP Trap Destination Address area.
3. In the Traps area, enter the name in the TRAP Community Name box.
4. Select the Traps to be received. The Traps are:
• Printer Traps.
• Cold Start Generic Traps.
• Warm Start Generic Traps.
• Authentic Failure Generic Traps.
Note When Authentication Failure Generic Trap is enabled, the machine will generate a trap for
every SNMP request that is received by the machine which contains an invalid community name.
5. Click on the Apply button to accept the changes.
If prompted, enter the Administrator’s User ID admin and Password 1111, and click on Login.
To Next Page
Loading...
