Printer Drivers
Phaser 4622
System Administrator Guide
54
11. Select the correct printer model from the list.
12. Click on the Next button. The printer driver will install.
13. Click on the Finish button.
Configure your Printer Driver
Information Checklist
Before starting the Installation procedure, please ensure that the following items are available and/or
the tasks have been performed:
1. The Phaser 4622 printer driver should be installed on your Windows operating system.
Procedure
1. At your workstation, open your Printers folder.
2. Right-click on the printer.
3. Click on Properties.
4. Click on Configuration.
Bi-Directional Setup
1. The driver can be set to automatically obtain information on the installed hardware options and
status of the device.
2. Click on Bi-Directional Setup.
3. Click on Automatic to have the driver automatically configure the IP address of the device or click
on Manual and enter the IP address or host name of the device.
4. If you want to change the default SNMP settings, click on SNMP Community Name and enter the
required information.
5. Click on the OK button.
Installable Options
1. If Bi-directional Setup is enabled, the driver will update with the options installed on the device.
2. If Bi-directional setup is not enabled, select the options that are installed on your device.
3. Click on the OK button.
Accounting
If you have Network Accounting installed, you can enable Accounting in the driver. For further
information, see Chapter 5, Network Accounting on page 65.
1. Click on the OK button to close your printer driver Properties.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
