102 5 Control Panel Menus
[Printer Settings]
The [Printer Settings] menu allows you to set print density, paper trays, and the Auto Tray
Selection feature.
[Density]
[Substitute Tray]
Printer Settings
Density
Setting Item Description
Density Sets the print density.
• [Normal] (default)
Prints documents at standard density.
•[Darken +1]
Prints documents at slightly dark density.
•[Darken +2]
Prints documents at dark density.
• [Lighten +2]
Prints documents at light density.
• [Lighten +1]
Prints documents at slightly light density.
Printer Settings
Substitute Tray
Setting Item Description
Substitute Tray Sets whether to switch to another paper tray if the paper tray selected by Auto
Tray Selection runs out of paper. If using this feature, set the paper size for the
substitute tray.
• [Off] (default)
Does not substitute the tray, and displays a message asking to load paper
into the paper tray.
• [Larger Size]
Switches to another paper tray that contains the paper that is one size larger
than the size requested, and prints documents at 100% zoom ratio.
•[Closest Size]
Switches to another paper tray that contains the paper of the size closest to
the size requested, and prints documents at a reduced zoom ratio if
necessary.
• [Bypass Feed]
Switches to Tray 1 (Bypass tray) and prints documents on the paper loaded
in Tray 1 (Bypass tray).
Note
• These settings will be overridden by requests sent from computers.
To Next Page
Loading...
