142 7 Maintenance
Important
• Make sure that the power is on when replacing the print cartridge. Switching the power off erases the
print data in the printer and information accumulated in the memory.
• Do not expose the print cartridge to direct sunlight or strong light.
• Avoid exposure to strong light when installing the print cartridge and complete the installation in less
than one minute.
• Do not touch the surface of the photoconductor (drum). Do not place the print cartridge upright or upside
down. Doing so can damage the photoconductor (drum).
• The photoconductor (drum) protection shutter protects the photoconductor (drum) from exposure to
light.
• Do not open the photoconductor (drum) protection shutter unless necessary.
• We recommend you use the print cartridge within one year after removing it from the packaging.
• Place the print cartridge only on a flat surface.
Replacement Procedure
Use the following procedure to replace the print cartridge and to clean inside the printer.
1. If paper is loaded in Tray 1 (Bypass tray),
remove the paper and close Tray 1 (Bypass
tray) cover.
Important
• When closing Tray 1 (Bypass tray) cover, be careful
not to get your fingers caught between (the left or right
edge of) the cover and the printer.
2. Pull the front cover release levers ("A")
towards you and open the front cover.
3. Open the top cover.
Place the side with the handles facing up.
To Next Page
Loading...
Need help?
General