4.2 Loading Paper 69
Setting the Paper Sizes of the Trays
Use the following procedure when setting non-standard paper sizes for Tray 1 or trays 2 -
5. If you loaded non-standard-size paper into tray 2, 3, 4 or 5, set the paper size dial to [
*
].
Note
• If you changed the paper loaded in tray 2, 3, 4 or 5 from non-standard-size paper to standard-size paper,
set the size of the paper with the paper size dial and not on the control panel.
1. Press the <Menu> button on the
control panel to display the menu screen.
2. Press the < > button until [Admin Menu] is
displayed.
3. Press the < > button to accept the
selection.
[Network/Port] is displayed.
4. Press the < > button until [Printer
Settings] is displayed.
5. Press the < > button to accept the
selection.
[Substitute Tray] is displayed.
6. Press the < > button until [Paper Size] is
displayed.
7. Press the < > button to accept the
selection.
[Tray 2] is displayed.
8. Press the < > button until the desired tray
is displayed. Press the < > button to move
to the right field and then press the < >
button.
[Tray 2 Custom] is displayed.
9. Press the <OK/Eject> button to
confirm your selection.
[Portrait (Y)] is displayed.
10. Press the < > button to select [Portrait
(Y)].
The current setting is displayed.
11. Enter the length using the < > or < >
button and press the <OK/Eject>
button to confirm your entry.
(Example: 431 mm)
Menu
Print Language
Menu
Admin Menu
Admin Menu
Network / Port
Admin Menu
Printer Settings
Printer Settings
Substitute Tray
Printer Settings
Paper Size
Paper Size
Tray 2 A4-P*
Paper Size
Tray 2 Custom
Tray 2 Custom
Portrait (Y)
Portrait (Y)
148mm*
Portrait (Y)
431mm
To Next Page
Loading...
